KLB-SYSTEM EPOXY EP 785 HS

Low-emission, vapour-permeable 2-C-Epoxy-Resin-Free-Flow-Coating.

KLB-SYSTEM EPOXY EP 785 HS is a solventfree, pigmented flow-coating based on a water-emulsified 2-Component-Epoxy-Resin- System with very good free-flow and planing properties. The special advantage of this system relies on the composition which results in a vapour-permeable film. The constituent parts are all adjusted vapourpermeable. It is especially suitable for reconstruction of magnesia-screed, sensitive to humidity as well as for soil-contacting substrate without adequate sealing. KLB-SYSTEM EPOXY EP 785 HS results in a smooth, fine non-slip, very appealing, matt surface. The coating is suitable for commercially and industrially used areas with medium load. Usage in wet areas is not recommended.

Application Area:
- Commercially and industrially used areas
with a light to medium load
- Mainly for dry areas
- Reconstruction of magnesia coatings
- For substrate with ascending humidity
- For new buildings with increased humidity
in the substrate

Build-up of System
Layer in Detail
Smooth Coating Scattered (slip-resistant) R11
Lamination strength 1.5 – 2.5 mm 2 – 4 mm
Sealer KLB-SYSTEM EPOXY EP 740 E, alternative: 1. Layer: KLB-SYSTEM EPOXY EP 785 HS
EP 701 E or PS 88 Maintenance Sealer 2. Layer: KLB-SYSTEM EPOXY EP 740 E
Coating KLB-SYSTEM EPOXY EP 785 HS
Primary Layer KLB-SYSTEM EPOXY EP 785 HS
and Scattering primary layer completely scattered
with quartz sand 0.3/0.8 mm
Scratch Coat KLB-SYSTEM EPOXY EP 782 E Optional for increased depth of roughness
Filling Primer
Base Coat KLB-SYSTEM EPOXY EP 727 E KLB-SYSTEM EPOXY EP 727 E
Substrate Requirements to the substrate according to the BEB-worksheets
and our detailed base coat instructions or advice by our technicians.

System Variant
Layer in Detail
Decorative Scattering Adding partiColor®-Chips and subsequently sealing is suitable for the coloured design.
Apply a matt sealer finish.
Increasing the To slightly increase the slip resistance grade seal with the RHX-additive added.
Slip-Resistance Grade
Glossy Maintenance KLB-SYSTEM Industrial Floor Maintenance PS 88
Matting KLB-SYSTEM EPOXY EP 705 E / EP 706 E
Alternative Coatings Economic: Apply KLB-SYSTEM EPOXY EP 740 E twice
Electrically conductive: KLB-SYSTEM EPOXY EP 785 EL+
Commercially and industrially used coatings can be produced as follows: