KLB-SYSTEM EPOXY EP 785 EL+

Electrically conductive, vapour-permeable 2-C-Epoxy-Resin-Free- Flow-Coating.

KLB-SYSTEM EPOXY EP 785 EL+ is a solvent- free, pigmented free-flow coating based on a water emulsified 2-Component- Epoxy-Resin-System with very good free-flow and planing properties. The particular advantage of this coating system is the special composition which results in a vapour-permeable coating. The parts are all adjusted steam-permeable and especially suitable for magnesia screed. Also suitable for soil-contacting substrate without sufficient sealing. KLB-SYSTEM EPOXY EP 785 EL+ is adjusted electrically conductive and results in a fine non-slip, very appealing, matt surface. The coating is suitable for commercially and industrially used areas with medium. mechanical load with requirements to conductivity. Not recommended for wet areas.

Application Area:
- Commercially and industrially used coatings
with demands to the electrical conductivity
with light to medium load
- Mainly for dry interior areas
- Reconstruction of magnesia coatings
- For substrate with ascending humidity
- For new coatings with increased humidity

Build-up of System
Layer in Detail
Smooth Coating
Lamination Strength 1.5 – 2.5 mm
Sealer KLB-SYSTEM EPOXY EP 790 EL+ and Maintenance PS 90
Coating KLB-SYSTEM EPOXY EP 785 EL+
Conductive Coat Install grounding system with copper bands on 1 - 2 spots for each 100 m².
and Grounding Apply the conductive coat KLB-SYSTEM EPOXID EP 799 Conductive Coat
Scratch Coat KLB-SYSTEM EPOXY EP 782 E Filling Primer
Base Coat KLB-SYSTEM EPOXY EP 727 E
Substrate Requirements to the substrate according to the BEB-worksheets
and our detailed base coat instructions or advice by our technicians.

System Variant
Layer in Detail
Increasing the To slightly increase the slip resistance grade scatter with silicum carbide.
Slip-Resistance Grade
Alternative Coatings Steam Tight: KLB-SYSTEM EPOXY EP 200 EL+, EP 211 ESD or EP 212 ESD
Elastic: KLB-SYSTEM POLYURETHANE PU 413 EL+
For WHG-requirements: KLB-SYSTEM EPOXY EP 280 WHG
Resistant to Chemicals: KLB-SYSTEM EPOXY EP 285 EL+
Commercially and industrially used coatings can be produced as follows:

Seek advice for requirements to explosion protection!