KLB-SYSTEM EPOXY EP 211 ESD
Homogeneous conductive 2-C-Epoxy-Resin-Coating for increased requirements to ESD-areas and transition resistance.
- For all areas of electronics and electrical
engineering with requirements to ESD like
e. g. test rooms, laboratories, assembly
halls, stockage areas and many more
Build-up of System
Layer in Detail
Smooth Coating Smooth Coating
Lamination strength 1.5 – 2.5 mm 1 – 2 mm
Coating Standard: High-Quality:
KLB-SYSTEM EPOXY EP 211 ESD KLB-SYSTEM EPOXY EP 212 ESD
Conductive Coat Install grounding system with copper bands on 1 - 2 spots for each 100 m².
and Grounding Apply the conductive coat KLB-SYSTEM EPOXY EP 799 Conductive Coat
Scratch Coat KLB-SYSTEM EPOXY EP 50 mixed with KLB-Sand Blend 2/1
Base Coat KLB-SYSTEM EPOXY EP 50
Substrate Requirements to the substrate according to the BEB-worksheets
and our detailed base coat instructions or advice by our technicians.
Layer in Detail
Increasing the To slightly increase the slip resistance grade scatter with silicum carbide.
Matting For a matt surface additionally apply KLB-SYSTEM POLYURETHANE PU 881 EL+ .
Alternative Coatings Standard: KLB-SYSTEM EPOXY EP 200 EL+
For ESD-requirements: KLB-SYSTEM EPOXY EP 211 ESD, EP 212 ESD or EP 200 EL+
combined with PU 881 EL+
Elastic: KLB-SYSTEM POLYURETHANE PU 413 EL+
Vapour-permeable: KLB-SYSTEM EPOXY EP 785 EL+ or EP 790 EL+
For WHG-requirements: KLB-SYSTEM EPOXY EP 280 WHG
Resistant to Chemicals: KLB-SYSTEM EPOXY EP 285 EL+
Commercially and industrially used coatings can be produced as follows: